Help/Support iGG Speed Hack - Data Refresh Set me Back Hours - fixable?

Ambrosianyc · June 10, 2022

Hi,

I used the iGG Speed Hack on a game, and it worked, but then the game data refreshed while it was on and it set me back 8 hours. Is there a way to revert this? Basically i'm wondering if I can find the equivalent number in iGG. I have 8 hours left on a production which usually only takes 1 hr, because I used the speed hack. I doubt it's possible in iGG but i was wondering if i could find the 8 hours in some kind of digit form and change it.

VaaR · June 10, 2022

Fuzzy search?

Ambrosianyc · June 10, 2022

2 minutes ago, VaaR said:

Fuzzy search?

i don't know how to use it

VaaR · June 10, 2022

Since it’s a countdown it should always be decreasing so in fuzzy search just keep searching for decreasing every time the number gets smaller until you only have a few options left to modify

Updated June 10, 2022 by VaaR

Ambrosianyc · June 11, 2022

35 minutes ago, VaaR said:

Since it’s a countdown it should always be decreasing so in fuzzy search just keep searching for decreasing every time the number gets smaller until you only have a few options left to modify

the results are so weird, it's the same group of numbers pretty much and they decrease and increase but it's never consistent one way or the other

VaaR · June 11, 2022

2 minutes ago, Ambrosianyc said:

the results are so weird, it's the same group of numbers pretty much and they decrease and increase but it's never consistent one way or the other

Just keep doing it until you only have a few results left. Then just change 1 number

Wait can’t you just use the speed hack again?

Updated June 11, 2022 by VaaR

Ambrosianyc · June 11, 2022

just constantly going back and doing the same fuzzy search? it didn't let me choose where (i4, i8 etc) all* is the only option

what's the difference between decreased/unchange and increased/change?

VaaR · June 12, 2022

On 6/11/2022 at 1:21 AM, Ambrosianyc said:

just constantly going back and doing the same fuzzy search? it didn't let me choose where (i4, i8 etc) all* is the only option

what's the difference between decreased/unchange and increased/change?

Decreased - You know the value you’re targeting decreased so using this option it will only look for decreased values

unchanged - The value you’re targeting didn’t change so using this will search for unchanged values

increased - The targeting value increased so use this option to target increased values

change - you know that the value changed but aren’t sure to what

I think that should be the easiest way to look at it

And yes constantly going back and doing fuzzy search until only some results show up