DIY Hack [Not Working] Brave Frontier Global 1.2.2 & 1.2.4 +22

Jazzmine · January 11, 2015

thank you for all the info!

FateEX · January 11, 2015

Ok, but is it normal when i modified for example "Inventory (Set inventory slots to 1000):" I found first 005CBAE8 which corresponds to "0C 46 6E F1 86 C8 02 30" than i copy and past " 64 20 0A 23 58 43 70 47". Save all and close. Now i have BraveFrontier and BraveFrontier.bak, i must copy BraveFrontier, but when i open it and search for inventory it returns to 0C 46 6E F1 86 C8 02 30. Its ok or an problem?

P.S: sorry for bad english

I tried putting the file of BraveFrontier instead Brave Frontier.bak and now the game will not open anymore. it is possible that with HxD on the PC has done something wrong? When I change the numbers are all red, must be red or am I doing something wrong?

Are you sure you are saving properly? Check the date modified for each file and use the one that is right. BAK is backup of the original file. It adds .bak so that the files don't have the same name. If it doesn't open, it most likely means you didn't set permissions or you changed the amount of bytes that it should have.

Hey Javi I downloaded the file and extracted it, set both ownerships to mobile and set all three permissions to read, write, execute, but the hex values that i look up for example godmode (003E14E0) doesn't appear and its always one letter or one number off. And i also get confused because there are eight columns and each one has two digits that correspond so i was also wondering where exactly do i enter the values.

Place your cursor, then search. The offset is where your cursor is. For example, it the offset you are looking for is 0x00000004 but to the left it shows 0x00000000, that just means count 4 bytes to the right. Each byte is a PAIR of alphanumerals from 0-F. So basically, the offset to the left is a guide to the correct offset. And eight columns is so that it fits on your screen without being too small. I zoom my screen in so it only shows 4 columns And if you're using iFile, use the BOX cursor so it replaces bytes as you type rather than inserting bytes.

Ninja fishy · January 12, 2015

Ty for this

Oximoron · January 12, 2015

Thanks

Oximoron · January 12, 2015

Hey, I need a little help with hex editor.. After clicking done it brings me back to the ifile documents folder and doesn't seem to save the edits I've done. Am I doing it wrong?

FateEX · January 12, 2015

Hey, I need a little help with hex editor.. After clicking done it brings me back to the ifile documents folder and doesn't seem to save the edits I've done. Am I doing it wrong?

Click done, and it should confirm save or cancel.